Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE1987SHADOW L4-135 2.2L SOHC TURBOREPAIR AND DIAGNOSISSTARTING AND CHARGINGSTARTING SYSTEMIGNITION SWITCHSERVICE AND REPAIR
1987 Dodge Shadow L4-135 2.2L SOHC Turbo
Ignition Switch: Service and Repair
1987 Dodge Shadow L4-135 2.2L SOHC TurboSECTION Service and Repair
Fig. 4 Ignition switch replacement. Exc. Horizon, Omni, Charger & Turismo:
EXC. HORIZON, OMNI, CHARGER & TURISMO
1. Disconnect battery ground cable.
2. Remove under panel sound deadener.
3. Disconnect speed control switch.
4. Remove two switch attaching screws, then rotate switch 90° and pull-up to disengage switch from rod.
5. Reverse procedure to install. When installing new switch push up gently on switch relieve slack in rod system.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.