Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE1987SHADOW L4-135 2.2L SOHC TURBOREPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL SWITCHTESTING AND INSPECTION
1987 Dodge Shadow L4-135 2.2L SOHC Turbo
Cruise Control Switch: Testing and Inspection
1987 Dodge Shadow L4-135 2.2L SOHC TurboSECTION Testing and Inspection
1. Check fuse for continuity.
2. Disconnect four wire electrical connector at steering column.
3. Connect a suitable 12 volt positive power source to yellow wire terminal.
4. With slide switch in the "On" position, attach one lead of a suitable test lamp to the brown wire with red tracer terminal. Connect the other lead to ground. Test lamp should go off when the "Set" button is depressed.
5. Attach test lamp lead to dark blue wire with white tracer terminal on 1982 - 87 FWD models and 1983 - 87 RWD models. On 1982 RWD models, connect test lead to dark blue wire terminal. Test lamp should light and go off when slide switch is moved to "Off" position.
6. With slide switch in the "On" position, attach test lead to white wire with red tracer terminal. Test lamp should light by either depressing "Set" button or by moving slide switch to "Resume."
7. Reconnect speed control lever harness connector to wiring harness connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.