Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Programming The Pcm
2013 Chrysler Town & Country S, GasSECTION Programming The Pcm
WARNING: This page is about a different car, the 2012 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Read all notes and cautions for programming procedures.
- Connect a battery charger to the vehicle.
- Connect the scan tool.
- Have a unique vehicle PIN readily available before running the routine.
- Ignition key should be in RUN position.CAUTION:
If the PCM and WIN are replaced at the same time, the PCM MUST be programmed before the WIN.
- Select "ECU View".
- Select "WIN Wireless Control".
- Select "Miscellaneous Functions."
- Select "PCM Replaced".
- Enter the PIN when prompted.
- Verify the correct information.
- Cycle ignition key after the successful routine completion.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.