Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2013TOWN & COUNTRY S, GASREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 27 (ELECTRONIC CONTROL MODULES (SERVICE INFORMATION))MODULE, DOORREMOVALREMOVAL
2013 Chrysler Town & Country S, Gas
Module, Door: Removal: Removal
2013 Chrysler Town & Country S, GasSECTION Removal
WARNING: This page is about a different car, the 2012 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the battery negative cable.
- Remove the lower trim panel from the inside of the front door. Refer to PANEL, DOOR TRIM, REMOVAL .
- Disconnect each of the electrical connectors from the connector receptacles of the door control module (2).
- Remove the two screws (3) that secure the door control module to the front door hardware module carrier (1).
- Remove the door control module from the door hardware module carrier.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.