Module, Blind Spot: Description: Description

Fig 1: Blind Spot Module

Courtesy of CHRYSLER GROUP, LLC

Blind Spot Module (1)  - Vehicles equipped with the blind spot monitor system include a module which is secured to a mounting bracket by two integrated latches and mounted in the electronic module tub (2), located beneath the left front seat assembly where it is concealed beneath a cover panel.

Hardwired circuitry connects the various blind spot monitor system components to each other through the electrical system of the vehicle. These hardwired circuits are integral to several wire harnesses, which are routed throughout the vehicle and retained by many different methods. These circuits may be connected to each other and to the vehicle electrical system through the use of a combination of soldered splices, splice block connectors, and many different types of wire harness terminal connectors and insulators. Refer to the appropriate wiring information. The wiring information includes wiring diagrams, proper wire and connector repair procedures, further details on wire harness routing and retention, as well as pin-out and location views for the various wire harness connectors, splices and grounds.

The blind spot monitor system components cannot be adjusted or repaired. If any of the BSM system components are damaged or inoperative, that component must be replaced. For more information on the blind spot monitor system and its components, refer to DESCRIPTION .