Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
3.6L/6.4L Gas/3.0L Diesel Vehicles
2013 Chrysler Town & Country S, GasSECTION 3.6L/6.4L Gas/3.0L Diesel Vehicles
WARNING: This page is about a different car, the 2013 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - CENTER CONSOLE LOWER TRIM PANEL |
| 2 - FLOOR CARPET |
- Pull loose the right side lower center console trim panel (1).
- Pull the right side floor carpet (2) back from under the center dash area.
1 - TRANSMISSION CONTROL MODULE 2 - WIRING CONNECTORS - While holding back the trim panel and the carpet, locate and release the 2 holding tabs on the TCM bracket to release the TCM (1).
- Slide the TCM (1) out of the mounting bracket.
- Disconnect the wiring harness connectors (2) from the module.
- Remove the module from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.