Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2013TOWN & COUNTRY S, GASREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 145 (ELECTRONIC CONTROL MODULES (SERVICE INFORMATION))MODULE, BLIND SPOTINSTALLATIONINSTALLATION
2013 Chrysler Town & Country S, Gas
Module, Blind Spot: Installation: Installation
2013 Chrysler Town & Country S, GasSECTION Installation
WARNING: This page is about a different car, the 2013 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Position the blind spot module (1) in the mounting bracket.
- Slide the module into place until the locking tabs are secure.
- Connect the body wire harness connector (3) to the module connector receptacle (4).
- Install the cover panel onto the electronic module tub.
- Connect the negative battery cable. For battery location and cable connection procedure, refer to CABLES, BATTERY, INSTALLATION .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.