Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2013TOWN & COUNTRY S, GASREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSPOWERTRAIN CONTROL MODULE (PCM) - ELECTRICAL DIAGNOSTICS - 62TE AUTOMATIC TRANSMISSIONDTC TROUBLESHOOTINGP0602-CONTROL MODULE PROGRAMMING ERROR/NOT PROGRAMMEDDIAGNOSTIC TEST
2013 Chrysler Town & Country S, Gas
Diagnostic Test
2013 Chrysler Town & Country S, GasSECTION Diagnostic Test
- CONTROL MODULE PROGRAMMING ERROR NOTE:
Controller is programmed with generic software and will not allow the correct vehicle Powertrain management.
- Record the controller part number.
- Update the controller with the correct software in accordance with the Service Information.
Verify that the controller updated successfully.
Test Complete
- Perform TRANSMISSION VERIFICATION TEST Refer to 62TE TRANSMISSION VERIFICATION TEST .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.