Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2013TOWN & COUNTRY S, GASREPAIR AND DIAGNOSIS (SINGLE PAGE)EXTERNAL PAGESDIFFERENT CARSECTION 162 ((STEERING CONTROL MODULE (SCM) - ELECTRICAL DIAGNOSTICS))
2013 Chrysler Town & Country S, Gas
Section 162 ((Steering Control Module (SCM) - Electrical Diagnostics))
2013 Chrysler Town & Country S, GasSECTION Section 162 ((Steering Control Module (SCM) - Electrical Diagnostics))
WARNING: This page is about a different car, the 2013 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Diagnostic Code Index
- DTC Troubleshooting
- B1425-2A-Remote Radio Switch Input-Stuck
- B1504-2A-Left Steering Wheel Control Switch-Stuck
- B1D9C-00-Steering Column Tilt Switch
- B1D9C-2A-Steering Column Tilt Switch- Stuck
- B2225-00-(SCM) Steering Column Module Internal
- B2306-2A-Front Washer Switch-Stuck
- B232E-00-Rear Washer Switch Stuck
- B2332-2A-Horn Switch-Stuck
- B23A1-2A-Flash To Pass/Optical Horn Switch-Stuck
- C1240-76-Steering Angle Sensor Angle OVERTRAVEL Performance- Wrong Mounting Position
- C2129-16-Battery Voltage-Circuit Voltage Below Threshold
- C2129-17-Battery Voltage-Circuit Voltage Above Threshold
- C212A-16-System Voltage-Circuit Voltage Below Threshold
- C212A-17-System Voltage-Circuit Voltage Above Threshold
- C2205-00-Steering Angle Sensor Internal
- C2205-29-Steering Angle Sensor Internal-Signal Invalid
- C2205-2F-Steering Angle Sensor Internal-Signal Erratic
- C2205-41-Steering Angle Sensor Internal-General Checksum Failure
- C2205-96-Steering Angle Sensor Internal-Component Internal Failure
- P0579-00-Speed Control Switch 1 Performance
- P0580-00-Speed Control Switch 1 Circuit Low
- P0581-00-Speed Control Switch 1 Circuit High
- P0585-00-Speed Control Switch 1/2 Correlation
- P0591-00-Speed Control Switch 2 Performance
- P0592-00-Speed Control Switch 2 Circuit Low
- P0593-00-Speed Control Switch 2 Circuit High
- P0815-2A-Upshift Switch - Stuck
- P0816-2A-Downshift Switch - Stuck
- P1593-2A-Speed Control Switch 1/2 Stuck
- U0002-00-Can C Bus Off Performance
- U0100-00-Lost Communication With Pcm
- U0146-00-Lost Communication With Central Gateway
- U0155-00-Lost Communication With Cluster/CCN
- U1008-00-Lin 1 Bus
- U1175-00-Lost Ignition Status Message
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.