Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Test
- SELECTING THE PROPER VERIFICATION TEST
The following verification tests are for different repairs. Select the appropriate Verification test for the repair that has been completed. If the battery was disconnected for any reason, you must perform the Battery Reconnection procedure in INSTALLATION .
Speed Control repair
- Go to step 2
Charging System repair
- Go to step 3
Evap System repair
- Go to step 4
All other repairs
- Go to step 5
- SPEED CONTROL VERIFICATION TEST NOTE:
If this vehicle is equipped with an Electronic Throttle Control system and the APP Sensors, PCM or Throttle Body Assembly have been replaced, use the scan tool to perform the ETC RELEARN function.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.