Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2013TOWN & COUNTRY S, GASREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEM3.6L - DTCS P0157 TO P0455DIAGNOSIS AND TESTINGP0161-O2 SENSOR 2/2 HEATER PERFORMANCESET CONDITION
2013 Chrysler Town & Country S, Gas
Set Condition
2013 Chrysler Town & Country S, GasSECTION Set Condition
No sensor output is received when the PCM powers up the O2 Sensor Heater. Two trip fault. Three good trips to turn off the MIL.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.