Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Test
- CHECK FOR AN ACTIVE DTC NOTE:
Before proceeding with the diagnostic procedure, verify that the connections are properly made, seated and verify proper pin terminal tension. A loose connection at any of the SCCM connectors may cause the DTC to set.
- Turn the ignition on.
- With the scan tool, perform the Steering Angle Sensor Initialization procedure.
- With the scan tool, read DTCs.
Does the scan tool display this DTC as active?
Yes
- Replace the Clockspring/SAS in accordance with the Service Information. Refer to CLOCKSPRING, REMOVAL .
- Perform the ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the appropriate wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform the ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.