Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2013TOWN & COUNTRY S, GAS/ETHANOLREPAIR AND DIAGNOSISQUICK LOOKUPSDTC INDEXSENSOR, RIGHT BLIND SPOT (RBSS)
2013 Chrysler Town & Country S, Gas/Ethanol
Sensor, Right Blind Spot (RBSS)
2013 Chrysler Town & Country S, Gas/EthanolSECTION Sensor, Right Blind Spot (RBSS)
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| B128D-2A | PASSENGER BLIND SPOT SENSOR - STUCK |
| B128D-48 | PASSENGER BLIND SPOT SENSOR - SUPERVISION SOFTWARE FAILURE |
| B128D-98 | PASSENGER BLIND SPOT SENSOR - COMPONENT OR SYSTEM OVER TEMPERATURE |
| B2199-16 | BATTERY VOLTAGE-CIRCUIT VOLTAGE BELOW THRESHOLD |
| B2199-17 | BATTERY VOLTAGE-CIRCUIT VOLTAGE ABOVE THRESHOLD |
| B223B-00 | VEHICLE CONFIGURATION MISMATCH |
| B2598-00 | DOOR MODULE FRONT LEFT |
| B2599-00 | DOOR MODULE FRONT RIGHT |
| U0011-00 | CAN INTERIOR BUS OFF PERFORMANCE |
| U0141-00 | LOST COMMUNICATION WITH IPM (FCM/TIPM) |
| U0155-00 | LOST COMMUNICATION WITH CLUSTER/CCN |
| U0184-00 | LOST COMMUNICATION WITH RADIO |
| U0203-00 | LOST COMMUNICATION WITH LEFT FRONT DOOR MODULE |
| U0204-00 | LOST COMMUNICATION WITH RIGHT FRONT DOOR MODULE |
| U1193-01 | LOST COMMUNICATION WITH DRIVER SIDE BLIND SPOT SENSOR - GENERAL ELECTRICAL FAILURE |
| U1193-87 | LOST COMMUNICATION WITH DRIVER SIDE BLIND SPOT SENSOR - MISSING MESSAGE |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.