Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2013TOWN & COUNTRY S, GAS/ETHANOLREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSIS3.6L - INTERMITTENT CONDITION, PCM/ECM REPROGRAMMING - GAS, PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE & POWERTRAIN VERIFICATION TESTSTANDARD PROCEDUREPCM/ECM REPROGRAMMING - GASSECTION 3 - AUTHORIZED MODIFICATION LABEL
2013 Chrysler Town & Country S, Gas/Ethanol
Section 3 - Authorized Modification Label
2013 Chrysler Town & Country S, Gas/EthanolSECTION Section 3 - Authorized Modification Label
NOTE:
The following step is required by law when reprogramming a PCM and/or TCM.
Type the necessary information on the "Authorized Modification Label" and attach near the VECI label.
- Powertrain Control/Transmission Control Module Part Numbers (Insert P/Ns) Used
- Change Authority: TSB XX--XX
- Dealer Code: XXXXX
- Date: XX-XX-XX
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.