Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2013TOWN & COUNTRY LIMITED, GAS/ETHANOLREPAIR AND DIAGNOSISGENERAL INFORMATIONOEM GENERAL INFORMATIONCIRCUIT TESTING PROCEDURES - NON-DTC-BASED DIAGNOSTICS
2013 Chrysler Town & Country Limited, Gas/Ethanol
Circuit Testing Procedures - Non-DTC-Based Diagnostics
2013 Chrysler Town & Country Limited, Gas/EthanolSECTION Circuit Testing Procedures - Non-DTC-Based Diagnostics
- Warning
- Description
- Diagnosis And Testing
- Standard Procedure
- Check A Battery Or Ignition Voltage Circuit With A 12-Volt Test Light
- Check A Circuit For A Short To Ground
- Check A Circuit For Voltage
- Check A Ground Circuit For An Open Using A 12-Volt Test Light
- Check For A Short Between Multiple Circuits
- Check For Excessive Current Draw
- Check The Resistance In A Circuit Using An Ohmmeter
- Check The Voltage On A 5-Volt Supply Circuit
- Electrostatic Discharge (ESD) Sensitive Devices
- Voltage Drop Test
- Wire Splicing
- Removal
- Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.