Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2003300M V6-3.5L VIN MREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSAIR TEMPERATURE SENSOR ( AMBIENT / INTAKE )SERVICE AND REPAIR
2003 Chrysler 300M V6-3.5L VIN M
Air Temperature Sensor ( Ambient / Intake ): Service and Repair
2003 Chrysler 300M V6-3.5L VIN MSECTION Service and Repair
Inlet Temperature Sensor 2.7L:
Inlet Temperature Sensor 3.5L:
REMOVAL
1. Remove the negative battery cable.
2. Disconnect electrical connector from sensor.
3. Remove sensor from clean air hose to throttle body.
INSTALLATION
1. Install sensor into clean air hose to throttle body.
2. Attach electrical connector to sensor.
3. Install the negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.