Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER1999CIRRUS L4-2.4L VIN XREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSWINDOW REGULATORSERVICE AND REPAIRFRONT DOOR WINDOW REGULATOR
1999 Chrysler Cirrus L4-2.4L VIN X
Front Door Window Regulator
1999 Chrysler Cirrus L4-2.4L VIN XSECTION Front Door Window Regulator
FRONT DOOR WINDOW REGULATOR
Power and manual door glass regulators are serviced using the same procedures. For power window motor service procedures refer to Power Windows.
REMOVAL
1. Remove door trim panel.
2. Separate glass from regulator roller channel.
3. Disengage power window motor wire connector, if equipped.
4. Loosen screw holding regulator scissor channel to door panel.
5. Separate screw and bolt heads from keyhole slots in door panel.
6. Loosen bolts holding regulator to door panel.
7. Separate regulator from door panel.
8. Slide regulator rearward and rotate forward end of roller channel through access hole in door panel.
INSTALLATION
1. Position regulator in door through access hole in door panel.
2. Position regulator on door panel.
3. Tighten bolts holding regulator to door panel.
4. Position screw and bolt heads in keyhole slots in door panel.
5. Tighten screw holding regulator scissor channel to door panel.
6. Engage power window motor wire connector, if equipped.
7. Position glass in regulator roller channel.
8. Tighten fasteners holding door glass to roller channel.
9. Install door trim panel.
Power and manual door glass regulators are serviced using the same procedures. For power window motor service procedures refer to Power Windows.
REMOVAL
1. Remove door trim panel.
2. Separate glass from regulator roller channel.
3. Disengage power window motor wire connector, if equipped.
4. Loosen screw holding regulator scissor channel to door panel.
5. Separate screw and bolt heads from keyhole slots in door panel.
6. Loosen bolts holding regulator to door panel.
Front Door Glass Regulator:
7. Separate regulator from door panel.
8. Slide regulator rearward and rotate forward end of roller channel through access hole in door panel.
INSTALLATION
1. Position regulator in door through access hole in door panel.
2. Position regulator on door panel.
3. Tighten bolts holding regulator to door panel.
4. Position screw and bolt heads in keyhole slots in door panel.
5. Tighten screw holding regulator scissor channel to door panel.
6. Engage power window motor wire connector, if equipped.
7. Position glass in regulator roller channel.
8. Tighten fasteners holding door glass to roller channel.
9. Install door trim panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.