Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER1999CIRRUS L4-2.4L VIN XREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - POWERTRAIN MANAGEMENTRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSBODY CONTROL MODULETESTING AND INSPECTIONSYMPTOM RELATED DIAGNOSTIC PROCEDURESWINDSHIELD WIPER AND WASHERWIPERS RUN CONSTANTLY W/IGNITION ON
1999 Chrysler Cirrus L4-2.4L VIN X
Wipers Run Constantly W/Ignition ON
1999 Chrysler Cirrus L4-2.4L VIN XSECTION Wipers Run Constantly W/Ignition ON
SYMPTOM
* WIPERS RUN CONSTANTLY W/IGNITION ON
POSSIBLE CAUSES
- Interm wiper relay control CKT SH/GND
- Interm wiper RLY/SUBSTI relay
- W/Wiper SW signal CKT-SH/Volts
- Wiper park switch sense circuit - short to ground
- Wiper park switch sense circuit open
- DEF Multi-function switch/switch connector
- defective wiper motor/wipers run constantly
- DEF BCM/Wipers SW SIG CKT
- Defective BCM- Wipers run constantly
- Defective wiper motor-runs constantly
* WIPERS RUN CONSTANTLY W/IGNITION ON
POSSIBLE CAUSES
- Interm wiper relay control CKT SH/GND
- Interm wiper RLY/SUBSTI relay
- W/Wiper SW signal CKT-SH/Volts
- Wiper park switch sense circuit - short to ground
- Wiper park switch sense circuit open
- DEF Multi-function switch/switch connector
- defective wiper motor/wipers run constantly
- DEF BCM/Wipers SW SIG CKT
- Defective BCM- Wipers run constantly
- Defective wiper motor-runs constantly
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.