Wiper Not Working At All

1999 Chrysler Cirrus L4-2.4L VIN XSECTION Wiper Not Working At All
SYMPTOM
* WIPER NOT WORKING AT ALL

POSSIBLE CAUSES
- SCI/PCI COMM failure- bus operational
- Open B (+) circuit- battery/wiper fuse
- Open ignition switch output circuit
- DEF intermittent wiper relay
- DEF intermittent wiper relay/RLY coil
- Fused B (+) circuit short/ground
- HI/LO wiper relay HI speed output circuit- short/GND
- Open fused B(+) circuit-between fuse/intermittent relay
- Open ground circuit
- Open intermittent wiper relay control circuit
- Open wiper relay common circuit between intermittent-HI/LO relay
- Wiper relay common CKT SH/GND
- HI/LO Wiper relay LO speed output circuit- short/GND
- Open HI/LO wiper LO speed output circuit between H/L RLY-WM
- Open wiper switch signal circuit between SW/BCM
- Wiper switch signal CKT short/ground
- Fused ignition switch output CKT SH/GND
- Open fused ignition switch output circuit
- Open fused ignition switch output circuit- switch/fuse #15
- DEF HI/LO wiper relay- wiper motor
- DEF HI/LO wiper relay-relay coil
- DEF multi-function switch/BCM
- DEF multi-function switch/fused ignition switch output CKT
- DEF wiper motor/ground CKT
- DEF wiper motor/H-L relay default
- DEF BCM/WIPER motor operate
- DEF BCM/WIPER motor actuation
- DEF BCM default

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.