Limp-In Mode - No Codes

1999 Chrysler Cirrus L4-2.4L VIN XSECTION Limp-In Mode - No Codes
Symptom:
* LIMP-IN MODE - NO CODES

POSSIBLE CAUSES
DEFECTIVE RELAY
INTERMITTENT RELAY CONNECTION
INTERMITTENT B (+) SPLICE TO RELAY
INTERMITTENT FUSED IGNITION SWITCH OUTPUT FEED TO TCM

Repair Instructions:
DEFECTIVE RELAY
Refer to Symptoms List, RELAY OUTPUT ALWAYS OFF.
Perform Transaxle 41 TE/AE Verification TEST VER-1A Verification Tests

INTERMITTENT RELAY CONNECTION
Refer to Symptoms List, RELAY OUTPUT ALWAYS OFF.
Perform Transaxle 41 TE/AE Verification TEST VER-1A Verification Tests

INTERMITTENT B W SPLICE TO RELAY
Refer to Symptoms List, RELAY OUTPUT ALWAYS OFF.
Perform Transaxle 41 TE/AE Verification TEST VER-1A Verification Tests

INTERMITTENT FUSED IGNITION SWITCH OUTPUT FEED TO TCM
Refer to Symptoms List, RELAY OUTPUT ALWAYS OFF.
Perform Transaxle 41 TE/AE Verification TEST VER-1A Verification Tests

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.