SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER1999CIRRUS L4-2.4L VIN XREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMIGNITION CABLESERVICE AND REPAIR
1999 Chrysler Cirrus L4-2.4L VIN X

Ignition Cable: Service and Repair

1999 Chrysler Cirrus L4-2.4L VIN XSECTION Service and Repair

Ignition Coil Pack:




Clean high tension cables with a cloth moistened with a non-flammable solvent. Wipe the cables dry. Check for brittle or cracked insulation.

Resistance cables are identified by the words Electronic Suppression

REMOVAL
Disconnect the cable from the ignition coil first. The cables insulate the spark plugs and cover the top of the spark plug tubes. To remove the cables, lightly grasp the top of the cable. Rotate the insulator 90° and pull straight up. Ensure the #1 and #4 cables run under the #2 and #3 ignition coil towers. Keep #4 cable away from the oil fill cap.

INSTALLATION
Ensure the #1 and #4 cables run under the #2 and #3 ignition coil towers. Keep #4 cable away from the oil fill cap.

Rotate the insulator 90° and push straight down. Connect the cable to the ignition coil.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.