Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
With Auto Trans
1999 Chrysler Cirrus L4-2.4L VIN XSECTION With Auto Trans
Speed Sensor - Output
Fig. 39:
CAUTION When disconnecting the speed sensor connector, be sure that the weather seal does not fall off or remain in old sensor.
The output speed sensor is located on the side of the transaxle, to the right of the manual shift lever.
The torque specification is 27 Nm (20 Ft Lbs).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.