Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER1999CIRRUS L4-2.4L VIN XREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSBODY CONTROL MODULETESTING AND INSPECTIONSYMPTOM RELATED DIAGNOSTIC PROCEDURESDOOR AJAROPEN DRIVER DOOR (LEFT FRONT) AJAR CIRCUIT
1999 Chrysler Cirrus L4-2.4L VIN X
Open Driver Door (Left Front) Ajar Circuit
1999 Chrysler Cirrus L4-2.4L VIN XSECTION Open Driver Door (Left Front) Ajar Circuit
SYMPTOM
* OPEN DRIVER DOOR (LEFT FRONT) AJAR CIRCUIT
TEST NOTE: All symptoms listed above are diagnosed using the same tests. The title for the tests will be * OPEN DRIVER DOOR (LEFT FRONT) AJAR CIRCUIT.
POSSIBLE CAUSES
- Body 20 way connector (CAV 7) defective
- Body control module defective open input (CAV 7)
- Left front door ajar switch defective open
- Left front door switch ground strap corroded/damaged
- LF door ajar (closed) switch sense circuit open
* OPEN DRIVER DOOR (LEFT FRONT) AJAR CIRCUIT
TEST NOTE: All symptoms listed above are diagnosed using the same tests. The title for the tests will be * OPEN DRIVER DOOR (LEFT FRONT) AJAR CIRCUIT.
POSSIBLE CAUSES
- Body 20 way connector (CAV 7) defective
- Body control module defective open input (CAV 7)
- Left front door ajar switch defective open
- Left front door switch ground strap corroded/damaged
- LF door ajar (closed) switch sense circuit open
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.