Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER1999CIRRUS L4-2.4L VIN XREPAIR AND DIAGNOSISMAINTENANCEALIGNMENTSERVICE AND REPAIRCURB HEIGHT MEASUREMENT
1999 Chrysler Cirrus L4-2.4L VIN X
Curb Height Measurement
1999 Chrysler Cirrus L4-2.4L VIN XSECTION Curb Height Measurement
The wheel alignment is to be checked and all alignment adjustments made with the vehicle at its required curb height specification.
Vehicle height is to be checked with the vehicle on a flat, level surface, preferably a vehicle alignment rack. The tires are to be inflated to the recommended pressure. All tires are to be the same size as standard equipment. Vehicle height is checked with the fuel tank full of fuel, and no passenger or luggage compartment load.
Vehicle height is not adjustable. If measurement is not within specifications, inspect vehicle for bent or weak suspension components. Compare parts tag on suspect coil spring(s) to parts book and vehicle sales code, checking for a match. Once removed from vehicle, compare coil spring height to a correct new or known good coil spring. The heights should vary if the suspect spring is weak.
1. Measure from the inboard edge of the wheel opening fender lip directly above the wheel center (spindle), to the floor or alignment rack surface.
2. When measuring, maximum left-to-right differential is not to exceed 20 min (0.79 inch).
3. Compare measurements to specifications listed in the following chart.
CURB HEIGHT SPECIFICATIONS
Vehicle height is to be checked with the vehicle on a flat, level surface, preferably a vehicle alignment rack. The tires are to be inflated to the recommended pressure. All tires are to be the same size as standard equipment. Vehicle height is checked with the fuel tank full of fuel, and no passenger or luggage compartment load.
Vehicle height is not adjustable. If measurement is not within specifications, inspect vehicle for bent or weak suspension components. Compare parts tag on suspect coil spring(s) to parts book and vehicle sales code, checking for a match. Once removed from vehicle, compare coil spring height to a correct new or known good coil spring. The heights should vary if the suspect spring is weak.
1. Measure from the inboard edge of the wheel opening fender lip directly above the wheel center (spindle), to the floor or alignment rack surface.
2. When measuring, maximum left-to-right differential is not to exceed 20 min (0.79 inch).
3. Compare measurements to specifications listed in the following chart.
CURB HEIGHT SPECIFICATIONS
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.