Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER1999300M V6-3.5L VIN GREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSBODY CONTROL MODULEDESCRIPTION AND OPERATIONMECHANICAL INSTRUMENT CLUSTER (MIC)
1999 Chrysler 300M V6-3.5L VIN G
Mechanical Instrument Cluster (MIC)
1999 Chrysler 300M V6-3.5L VIN GSECTION Mechanical Instrument Cluster (MIC)
The instrument cluster displays four gauges, a vacuum fluorescent (VF) odometer, a VF PRNDL and up to (18) indicators. One reset button is used to switch the display from trip to total. Holding the button when the display is in the trip mode will reset the trip mileage. The cluster also supplies the power for the panel illumination. Most of the information that is displayed is received over the PC bus from several modules.
With ignition in "lock", the cluster will wake up and display the door ajar and odometer display when a door is opened. The cluster will also wake up to control the panel illumination. In "off" (unlock) the PRNDL and several indicators will be functional but all gauges will not function. On transition from "off" (unlock) to run, the cluster will perform a check of all micro-controlled indicators, the odometer and the PRNDL for approx. 2 seconds. Other bulb checks with longer bulb check durations will be performed based on bus messages from other modules. If the cluster receives no PC bus messages for (20) seconds after the transition to "run", the cluster will display "no bus" in the odometer.
A self test can be initiated by holding down the odometer reset button and switching the ignition from "lock" to "off" (unlock). This test will activate the gauges, turn on the indicator lights along with the odometer and PRNDL segments.
With ignition in "lock", the cluster will wake up and display the door ajar and odometer display when a door is opened. The cluster will also wake up to control the panel illumination. In "off" (unlock) the PRNDL and several indicators will be functional but all gauges will not function. On transition from "off" (unlock) to run, the cluster will perform a check of all micro-controlled indicators, the odometer and the PRNDL for approx. 2 seconds. Other bulb checks with longer bulb check durations will be performed based on bus messages from other modules. If the cluster receives no PC bus messages for (20) seconds after the transition to "run", the cluster will display "no bus" in the odometer.
A self test can be initiated by holding down the odometer reset button and switching the ignition from "lock" to "off" (unlock). This test will activate the gauges, turn on the indicator lights along with the odometer and PRNDL segments.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.