Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Heated Steering Wheel Module (1) - Install
- Connect the electrical connector.
Steering Wheel Shroud (2) - Install
- Steering Wheel Spoke Cover Bolt (1) - Install and tighten [5x] - Fastener Specifications
Steering Wheel Spoke Cover Bolt (2) - Install and tighten [2x] - Fastener Specifications
- NOTE:
Left side shown, right side similar.
Automatic Transmission Manual Shift Auxiliary Position Switch - Left Side and Right Side (3) - Install [2x]
- Steering Wheel Spoke Cover Bolt - Left Side and Right Side (2) - Install and tighten [4x] - Fastener Specifications
Steering Wheel Trim Spoke Cover Applique (2) - Install
- Connect the electrical connector.
- Steering Wheel Spoke Cover Bolt (1) - Install and tighten [2x] - Fastener Specifications
Connect the electrical connectors and position the wiring harness. (2)
- Steering Wheel Spoke Cover Bolt (1) - Install and tighten - Fastener Specifications
Cruise Control Switch Bolt (1) - Install and tighten [2x] - Fastener Specifications
Connect the electrical connector.
- Steering Wheel (2) - Install
- If a NEW threaded component is being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded component is reused, prepare the threaded component using the following steps:
- Remove any loose cured adhesive from the external threads of the component using a lint free cloth.
- Thread the cleaned component into the internal mating threads and remove to loosen trapped cured adhesive.
- Remove loose debris from internal and external threads using compressed air.
- Apply liquid thread locking adhesive in a strip along half of the length of the external threads, starting at the tip, just prior to installation. Adhesives, Fluids, Lubricants, and Sealers
- Steering Wheel Bolt (1) - Install and tighten - Fastener Specifications
Connect the electrical connector.
- Steering Wheel Airbag (1) - Install
Steering Wheel Airbag Bolt (1) - Install and tighten [2x] - Fastener Specifications
Install the left and right steering wheel airbag access hole covers (1).
- Enable the SIR System. SIR Disabling and Enabling
Refer to Fastener Caution .
After installation of the steering wheel airbag module to the steering wheel, slightly pull the module outward. If there is no give on the airbag module then it is secured correctly. If the airbag module is not fully attached personal injury could result.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.