Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025TRAVERSE HIGH COUNTRY, FWDREPAIR AND DIAGNOSISSTEERINGMANUAL STEERINGPOWER STEERING SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESDTC C1168CIRCUIT/SYSTEM VERIFICATION
2025 Chevrolet Traverse High Country, FWD
Circuit/System Verification
2025 Chevrolet Traverse High Country, FWDSECTION Circuit/System Verification
NOTE:
DTC C1168 is an information DTC that will set along with other DTCs. To correct DTC C1168, diagnose and repair any other DTCs, then clear DTC C1168.
- Ignition ON/Vehicle in Service Mode.
- Verify that no DTCs related to the power steering system are set.
- If any DTCs are set
- Go to next step: If no DTCs are set
- All OK.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.