Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Install Fuel Pump Power Control Module to Fuel Pump Power Control Module bracket as an assembly..
- Fuel Pump Power Control Module (2) - Install
- Connect the electrical connector.
- Fuel Pump Power Control Module Fastener (1) - Install and tighten [2x] - Fastener Specifications
- Install the retainers.
- Lowering the vehicle.
Refer to Fastener Caution .
Install Fuel Pump Power Control Module to Fuel Pump Power Control Module bracket as an assembly..
- Fuel Pump Power Control Module (2) - Install
- Fuel Pump Power Control Module Fastener (1) - Install and tighten [2x] - Fastener Specifications
- Connect the electrical connectors and install the wiring harness retainers as necessary.
- Lowering the vehicle.
Refer to Fastener Caution .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.