Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025TRAVERSE HIGH COUNTRY, FWDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTILOCK BRAKE SYSTEMREPAIR INSTRUCTIONSVEHICLE DYNAMICS SENSOR REPLACEMENTREMOVAL PROCEDURE
2025 Chevrolet Traverse High Country, FWD
Removal Procedure
2025 Chevrolet Traverse High Country, FWDSECTION Removal Procedure
NOTE:
Some components not shown for graphic clarity.
- With the aid of an assistant, remove the console from the vehicle. (1) FRONT FLOOR CONSOLE REMOVAL AND INSTALLATION
- Disconnect the electrical connector.
- Vehicle Dynamic Sensor Nut (1) » Remove [2x]
- Vehicle Dynamic Sensor (1) » Remove
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.