Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
Windshield Multifunction Sensor Mount Bracket Cover Insert (1) - Remove
Windshield Multifunction Sensor Mount Bracket Cover (1) - Remove
Inside Rearview Mirror Bolt (1) - Remove
- Inside Rearview Mirror (2) - Remove
Disconnect the electrical connector.
- Release the retaining tabs.
- Slide the front view camera (1) upward to release.
- Front View Camera (1) - Remove
- NOTE:
Do NOT remove or service the sensor farm pins.
Front View Driver Information Camera Bracket (1) - Remove
- Release the front view driver information camera bracket (1) retaining tabs and slide the bracket upward to disengage the sensor farm pins.
- Gently pull the front view driver information camera bracket (1) away from the windshield.
Observe the mounting and location of the front view camera to ensure proper reinstallation.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.