Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025TRAVERSE HIGH COUNTRY, FWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSK182 PARKING ASSIST CONTROL MODULE: PROGRAMMING AND SETUPUNSUCCESSFUL PROGRAMMING RECOVERY
2025 Chevrolet Traverse High Country, FWD
Unsuccessful Programming Recovery
2025 Chevrolet Traverse High Country, FWDSECTION Unsuccessful Programming Recovery
In the event of an interrupted or unsuccessful programming event, perform the following steps:
- Ignition ON. Ensure the K182 Parking Assist Control Module, DLC and programming tool connections are secure and the SPS software is up to date.
- Verify the parking assist control module can be reprogrammed.
- If the K182 Parking Assist Control Module cannot be reprogrammed
- Ignition OFF for one minute, ignition ON.
- Verify the parking assist control module can be reprogrammed.
- If the K182 Parking Assist Control Module cannot be reprogrammed, replace the parking assist control module.
- Go to next step: If the K182 Parking Assist Control Module can be reprogrammed.
- All OK.
- Go to next step: If the K182 Parking Assist Control Module can be reprogrammed
- All OK.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.