SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025TRAVERSE HIGH COUNTRY, FWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSK124 IMAGE PROCESSING MODULE: PROGRAMMING AND SETUP (WITH UKL)UNSUCCESSFUL PROGRAMMING RECOVERY
2025 Chevrolet Traverse High Country, FWD

Unsuccessful Programming Recovery

2025 Chevrolet Traverse High Country, FWDSECTION Unsuccessful Programming Recovery

In the event of an interrupted or unsuccessful setup event, perform the following steps:

  1. Ignition/Vehicle OFF.
  2. Ensure the Image Processing Module, DLC and programming tool connections are secure and the SPS software is up to date.
  3. Ignition/Vehicle OFF, all access doors closed, all vehicle systems OFF for two minutes.
    • Attempt to reprogram the K124 Image Processing Module 
    1. Verify the K124 Image Processing Module can be reprogrammed.
      • If the image processing module cannot be reprogrammed, contact Techline Customer Support Center (TCSC).
      • Go to next step: If the K124 Image Processing Module can be reprogrammed.
    2. All OK.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.