Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025TRAILBLAZER LT, 1.2L ENG VIN PREPAIR AND DIAGNOSISGENERAL INFORMATIONRESET PROCEDURESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSB218R SIDE OBJECT SENSOR MODULE - RIGHT: PROGRAMMING AND SETUPREPLACE AND PROGRAM ECU OR REPROGRAM ECU
2025 Chevrolet Trailblazer LT, 1.2L Eng VIN P
Replace and Program ECU or Reprogram ECU
2025 Chevrolet Trailblazer LT, 1.2L Eng VIN PSECTION Replace and Program ECU or Reprogram ECU
To program a replacement or an existing ECU, perform the following procedure:
NOTE:
- Due to continuous improvements, the on screen selections may vary from instructions below.
- It is recommended to program both the left and right (if programmable) when a programming event is required.
- Some systems only have one programmable Side Object Sensor Module.
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select B218L/R Side Object Sensor Module or B218R Right Side Object Sensor Module or B218L Left Side Object Detection.
- On the SPS Select Function / Sequence screen, select Sequential Programming or Programming
- Clear DTCs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.