Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
Rear Bumper Fascia (1) - Remove - Rear Bumper Fascia Replacement
Rear Closure Hands Free Sensor Shield (2) - Remove - Rear Closure Hands Free Sensor Shield Replacement
Wiring Harness Retainer (1) - Remove [2x]
- Wiring Harness (2) - Reposition
Rear Closure Hands Free Module Screw (1) - Remove [2x]
- Disconnect the electrical connector.
- Rear Closure Hands Free Module (2) - Remove
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.