Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025TRAILBLAZER LS, 1.2L ENG VIN PREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEBODY, CAB CONTROL SYSTEMSVEHICLE ACCESS SYSTEMREPAIR INSTRUCTIONSLIFTGATE SIDE SENSOR REPLACEMENT
2025 Chevrolet Trailblazer LS, 1.2L Eng VIN P
Liftgate Side Sensor Replacement
2025 Chevrolet Trailblazer LS, 1.2L Eng VIN PSECTION Liftgate Side Sensor Replacement
| Callout | Component Name |
|---|---|
| Preliminary Procedure Liftgate Upper Side Trim Finish Panel Replacement |
|
| 1 | Rear End Spoiler Bolt
CAUTION:
Tighten 5 N.m (44 lb in) |
| 2 | Liftgate Side Sensor Retainer [4x] |
| 3 | Liftgate Side Sensor Procedure Disconnect the electrical connector. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.