Body Control Module Bracket Replacement

2025 Chevrolet Trailblazer LS, 1.2L Eng VIN PSECTION Body Control Module Bracket Replacement
GM5285022Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Instrument Panel Lower Center Trim Panel Replacement
  2. Floor Rear Air Outlet Duct Adapter Replacement - Left Side
  3. Floor Rear Air Outlet Duct Adapter Replacement - Right Side
  4. {If equipped} Instrument Panel Compartment Air Duct Replacement
  5. Low Frequency Instrument Panel Antenna Replacement
1 Body Control Module Bracket Bolt
Tighten 
2.5 N.m (22 lb in)
2 Body Control Module Bracket

Procedure

  1. Disconnect the electrical connectors from the body control module.
  2. Remove the bracket and replace parts as necessary.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.