Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025TRAILBLAZER ACTIV, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)SUSPENSIONWHEEL ALIGNMENTSPECIFICATIONSWHEEL ALIGNMENT SPECIFICATIONS
2025 Chevrolet Trailblazer ACTIV, FWD
Wheel Alignment Specifications
2025 Chevrolet Trailblazer ACTIV, FWDSECTION Wheel Alignment Specifications
Alignment Condition: Full tank of fuel, no passengers and placed on flat level surface.
Front Wheel Alignment Specification
| Drive Type | Caster | Cross Caster (L - R) |
Camber | Cross Camber (L - R) |
Total Toe (L+R) |
Steering Wheel Angle | |||
|---|---|---|---|---|---|---|---|---|---|
| Left | Right | Left | Right | ||||||
| FWD | 6.52° ± 1.50° | 6.52° ± 1.50° | ± 1.00° | -0.47° ± 1.00° | -0.47° ± 1.00° | ± 1.00° | 0.15° ± 0.20° | 0.00° ± 2.50° | |
| AWD | 225/60R17 | 6.37° ± 1.50° | 6.37° ± 1.50° | ± 1.00° | -0.25° ± 1.00° | -0.25° ± 1.00° | ± 1.00° | 0.15° ± 0.20° | 0.00° ± 2.50° |
| 225/55R18 | 6.37° ± 1.50° | 6.37° ± 1.50° | ± 1.00° | -0.30° ± 1.00° | -0.30° ± 1.00° | ± 1.00° | 0.15° ± 0.20° | 0.00° ± 2.50° | |
Rear Wheel Alignment Specification
| Drive Type | Caster | Cross Caster (L - R) |
Camber | Cross Camber (L - R) |
Total Toe (L+R) |
Thrust Angle | ||
|---|---|---|---|---|---|---|---|---|
| Left | Right | Left | Right | |||||
| All | - | - | - | -1.25° ± 0.75° | -1.25° ± 0.75° | ± 1.00° | 0.20° ± 0.35° | 0.00° ± 0.30° |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.