Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025TRAILBLAZER ACTIV, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSWIRING DIAGRAMSCOMPONENT CONNECTOR END VIEWS (K71-M81)COMPONENT CONNECTOR END VIEWSK84 KEYLESS ENTRY CONTROL MODULE X2
2025 Chevrolet Trailblazer ACTIV, FWD
K84 Keyless Entry Control Module X2
2025 Chevrolet Trailblazer ACTIV, FWDSECTION K84 Keyless Entry Control Module X2
Connector Part Information
|
Terminal Part Information
| Terminal Type ID | Terminated Lead | Diagnostic Test Probe | Terminal Removal Tool |
|---|---|---|---|
| I | 13584547 | J-35616-64B (L-BU) | J-38125-215A |
| Pin | Size | Color | Circuit | Function | Terminal Type ID | Option |
|---|---|---|---|---|---|---|
| 1 - 5 | - | - | - | Not Occupied | - | - |
| 6 | 0.35 | VT | 3560 | Driver Door Passive Entry Antenna High Signal | I | AVJ |
| 7 | 0.35 | VT / GY | 3561 | Driver Door Passive Entry Antenna Low Signal | I | AVJ |
| 8 | 0.5 | GY | 2066 | Hands-Free Liftgate Sensor Lamp Control | I | (AVJ+TC2) |
| 9 | 0.35 | GN / BK | 3563 | Passenger Door Passive Entry Antenna Low Signal | I | AVJ |
| 10 | - | - | - | Not Occupied | - | - |
| 11 | 0.35 | VT / WH | 3571 | Passenger Door Handle Switch Signal | I | AVJ |
| 12 | 0.35 | GN / WH | 3570 | Driver Door Handle Switch Signal | I | AVJ |
| 13 - 15 | - | - | - | Not Occupied | - | - |
| 16 | 0.35 | BN / GN | 3568 | Rear Closure Passive Entry Antenna High Signal | I | AVJ |
| 17 | - | - | - | Not Occupied | - | - |
| 18 | 0.35 | GN / GY | 3569 | Rear Closure Passive Entry Antenna Low Signal | I | AVJ |
| 19 | - | - | - | Not Occupied | - | - |
| 20 | 0.35 | GN / YE | 3562 | Passenger Door Passive Entry Antenna High Signal | I | AVJ |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.