Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Replace and Program Control Module or Reprogram Control Module
To program a replacement or an existing K56 Serial Data Gateway Module, perform the following procedure:
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K56A Serial Data Gateway Module Processor 1 - Programming and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K56B Serial Data Gateway Module Processor 2 - Programming and follow the on-screen instructions.
- Clear DTCs.
When programming K56 Serial Data Gateway Module, both processor 1 and processor 2 need to be updated. After programming processor 1, re-enter SPS and program processor 2.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.