Steering Gear Boot Replacement

2025 Chevrolet Trailblazer ACTIV, 4WDSECTION Steering Gear Boot Replacement
GM4024316Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Drivetrain and Front Suspension Cradle Removal and Installation (AWD) , or Drivetrain and Front Suspension Cradle Removal and Installation (FWD)
  2. Steering Linkage Outer Tie Rod Replacement 
1 Steering Gear Boot Inner Clamp- Small Clamp
2 Steering Gear Boot Inner Clamp- Large Clamp

Procedure

  1. Cut the steering gear boot inner clamp and discard the clamp.
  2. Use the CH-804  boot clamp plier to install a NEW steering gear boot inner clamp.

Special Tools 
CH-804  Boot Clamp Plier
Equivalent regional tools: Special Tools 
3 Steering Gear Boot

Procedure

  1. Inspect the steering linkage inner tie rod for evidence of corrosion or contamination. If corrosion or contamination is evident, replace the steering linkage inner tie rod. Steering Linkage Inner Tie Rod Replacement 
  2. Ensure the steering gear boot is seated in the appropriate groove on the steering gear before installing the steering gear boot clamp.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.