Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Connect the electrical connector.
- Accessory and Liftgate Control Module (1) - Install
Quarter Lower Rear Trim Panel (1) - Install
Body Lock Pillar Upper Trim Panel (2) - Right Side - Install - Body Lock Pillar Upper Trim Panel Replacement
Cargo Tie Down Loop (2) - Right Side - Install [2x] - Cargo Tie Down Loop Replacement
{If equipped} Convenience Net Retainer (1) - Install and tighten to 2.5 N.m (22 lb in)
Liftgate Sill Garnish Molding (1) - Install - Liftgate Sill Garnish Molding Replacement
Load Floor Stowage Compartment Cover (1) - Install - Load Floor Stowage Compartment Cover Replacement
Luggage Shade (1) - Install - Luggage Shade Replacement
- Perform the necessary programming and setup procedure: K39 Liftgate Control Module: Programming and Setup (Without 09F) , or K39 Liftgate Control Module: Programming and Setup (With 09F)
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.