Replace and Program Control Module or Reprogram Control Module

2025 Chevrolet Trailblazer ACTIV, 4WDSECTION Replace and Program Control Module or Reprogram Control Module
  1. Access the Service Programming System (SPS) and follow the on-screen instructions.
  2. With the Power Steering Assist Motor replaced and reconnected, on the SPS Supported Controllers screen, select K43 Power Steering Control Module - Programming and follow the on-screen instructions.
  3. Ignition OFF and all vehicle systems OFF. It may take up to 2 minutes for all vehicle systems to power down.
  4. Ignition ON.
  5. On the SPS Supported Controllers screen, select K43 Power Steering Control Module - Setup and follow the on-screen instructions.
  6. Clear DTCs.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.