Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Vehicle Stability Control System Switch (1) - Install
- Ensure that the retaining tabs are fully secured.
Connect the electrical connectors.
- Instrument Panel Outer Air Outlet - Left Side (1) - Install
- CAUTION:
Refer to Fastener Caution .
Instrument Panel Outer Air Outlet Bolt (1) - Install and tighten [3x] - Fastener Specifications
Instrument Panel Center Trim Pad - Left Side (1) - Install
Instrument Panel Trim Pad - Left Side (1) - Install
Instrument Panel Outer Trim Cover - Left Side (1) - Install
Instrument Panel Lower Trim Panel Outer Filler (1) - Install
Connect the electrical connectors.
- Radio Control (1) - Install
Radio Control Bolt (1) - Install and tighten [6x] - Fastener Specifications
Instrument Panel Upper Trim Panel Cover (1) - Install
Instrument Panel Trim Plate Applique - Right Side (1) - Install
Instrument Panel Trim Plate Applique Bolt (1) - Install and tighten [8x] - Fastener Specifications
Connect the electrical connector.
- Instrument Panel Center Trim Pad - Right Side (1) - Install
Instrument Panel Lower Trim Panel Bolt (1) - Install and tighten - Fastener Specifications
Instrument Panel Fuse Block Access Hole Cover - Right Side (1) - Install
Connect the electrical connectors.
- Instrument Panel Cluster Control Module (1) - Install
Instrument Cluster Bolt (1) - Install and tighten [4x] - Fastener Specifications
Instrument Panel Extension (1) - Install
Windshield Garnish Molding - Right Side (3) - Install
- Windshield Pillar Assist Handle Bolt (2) - Install and tighten [2x] - Fastener Specifications
- Windshield Pillar Assist Handle Cover (1) - Install [2x]
- Reposition the weatherstrip as necessary.
Windshield Garnish Molding Bolt (3) - Install and tighten - Fastener Specifications
- Align the retaining clips (2) with the slots in the A pillar and press the windshield garnish molding (1) into place.
Windshield Garnish Molding - Left Side (1) - Install
- Enable the SIR System. SIR Disabling and Enabling
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.