Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025TAHOE PPV, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTMEMORY MODULESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSK183 UHF SHORT RANGE LOW ENERGY REMOTE CONTROL ACCESS TRANSCEIVER: PROGRAMMING AND SETUPREPROGRAM CONTROL MODULE
2025 Chevrolet Tahoe PPV, 4WD
Reprogram Control Module
2025 Chevrolet Tahoe PPV, 4WDSECTION Reprogram Control Module
Do not reprogram the module, unless directed by a service procedure, or a service bulletin.
To reprogram an existing control module, perform the following procedure:
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, under Select Controller, select K183 UHF Short Range Low Energy Remote Control Access Transceiver.
- On the SPS Supported Controllers screen, under Select Function / Sequence, select Programming and follow on screen instructions.
- Clear DTCs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.