Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Serial Data Gateway Module (1) - Install
- Secure the retaining tabs.
- Connect the electrical connectors.
- Connect the accelerator pedal electrical connector.
- WARNING:
Upon installing the floor duct to the side of the HVAC case, it is necessary to verify duct opening is completely installed, surrounding the HVAC case outlet port. Failure to do so could result in the duct falling downward, with the potential to interfere with driver's legs and gas/brake pedal operation.
Floor Front Air Outlet Duct - Left Side (1) - Install
- CAUTION:
Refer to Fastener Caution .
Floor Front Air Outlet Duct Bolt (1) - Install and tighten - Fastener Specifications
Instrument Panel Lower Trim Panel Insulator (1) - Install
Instrument Panel Lower Insulator Retainer (1) - Install [2x]
- Perform the necessary programming and setup procedure:Control Module References
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.