SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025TAHOE COMMERCIAL, 4WDREPAIR AND DIAGNOSISSTEERINGPOWER STEERING SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESDTC C1119CIRCUIT/SYSTEM VERIFICATION
2025 Chevrolet Tahoe Commercial, 4WD

Circuit/System Verification

2025 Chevrolet Tahoe Commercial, 4WDSECTION Circuit/System Verification
  1. Verify that all harness connectors are installed properly at the K43 Power Steering Control Module.
    • If a harness connector at the K43 Power Steering Control Module is not installed properly 
    1. Connect the appropriate harness connector properly at the K43 Power Steering Control Module.
    2. Verify the DTC does not set.
      • If the DTC sets, replace the Steering Gear.
      • Go to next step: If the DTC does not set
    3. All OK.
    • Go to next step: If all harness connectors at the K43 Power Steering Control Module are installed properly 
  2. Ignition ON.
  3. Verify the scan tool Torque Sensor parameter changes when turning the steering wheel.
    • If the parameter does not change 

      Replace the Steering Gear.

    • Go to next step: If the parameter changes 
  4. All OK.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.