Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Vehicle Stability Control System Switch (1) - Install
- Ensure that the retaining tabs are fully secured.
Connect the electrical connectors.
- Instrument Panel Outer Air Outlet - Left Side (1) - Install
- CAUTION:
Refer to Fastener Caution .
Instrument Panel Outer Air Outlet Bolt (1) - Install and tighten [3x] - Fastener Specifications
Instrument Panel Center Trim Pad - Left Side (1) - Install
Instrument Panel Trim Pad - Left Side (1) - Install
Instrument Panel Outer Trim Cover - Left Side (1) - Install
Instrument Panel Lower Trim Panel Outer Filler (1) - Install
Connect the electrical connectors.
- Radio Control (1) - Install
Radio Control Bolt (1) - Install and tighten [6x] - Fastener Specifications
Instrument Panel Trim Plate Applique - Right Side (1) - Install
Instrument Panel Trim Plate Applique Bolt (1) - Install and tighten [8x] - Fastener Specifications
Connect the electrical connectors.
- Instrument Panel Center Trim Pad - Right Side (1) - Install
Instrument Panel Lower Trim Panel Bolt (1) - Install and tighten - Fastener Specifications
Instrument Panel Fuse Block Access Hole Cover - Right Side (1) - Install
Connect the electrical connectors.
- Instrument Panel Cluster Control Module (1) - Install
Instrument Cluster Bolt (1) - Install and tighten [4x] - Fastener Specifications
Instrument Panel Upper Trim Panel Cover (1) - Install
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.