Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025TAHOE COMMERCIAL, 4WDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTILOCK BRAKE SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESTRACTION CONTROL/STABILITY CONTROL INDICATOR MALFUNCTIONCOMPONENT TESTING
2025 Chevrolet Tahoe Commercial, 4WD
Component Testing
2025 Chevrolet Tahoe Commercial, 4WDSECTION Component Testing
- Ignition OFF, disconnect the harness connector at the S86 Vehicle Stability Control System Switch.
- Test for infinite resistance between the signal terminal 1 and the ground terminal 10 with the switch in the open position.
- If less than infinite resistance
Replace the S86 Vehicle Stability Control System Switch.
- Go to next step: If infinite resistance
- If less than infinite resistance
- Test for less than 2 Ω between the signal circuit terminal 1 and the ground terminal 10 with the switch in the closed position.
- If 2 Ω or greater
Replace the S86 Vehicle Stability Control System Switch.
- Go to next step: If less than 2 Ω
- If 2 Ω or greater
- All OK.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.