Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025TAHOE COMMERCIAL, 4WDREPAIR AND DIAGNOSISBODY & FRAMETOWING SYSTEMSTRAILERING SYSTEMSREPAIR INSTRUCTIONSTRAILER LAMP CONTROL MODULE REPLACEMENTREMOVAL PROCEDURE
2025 Chevrolet Tahoe Commercial, 4WD
Removal Procedure
2025 Chevrolet Tahoe Commercial, 4WDSECTION Removal Procedure
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection (9C1 / 5W4) , or Battery Negative Cable Disconnection and Connection (KL9)
- Raise and support the vehicle. Lifting and Jacking the Vehicle
Electrical Connector (1) @ Trailer Lamp Control Module - Disconnect
Trailer Lamp Control Module Bracket Nut (1) - Remove [2x]
- Trailer Lamp Control Module (2) - Remove
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.