Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025TAHOE COMMERCIAL, 4WDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSKEYLESS ENTRY SYSTEM AND REMOTE FUNCTIONSREPAIR INSTRUCTIONSDIGITAL KEY SENSOR POSITION LEARNUHF - VKM SENSOR POSITION LEARN
2025 Chevrolet Tahoe Commercial, 4WD
UHF - VKM Sensor Position Learn
2025 Chevrolet Tahoe Commercial, 4WDSECTION UHF - VKM Sensor Position Learn
To complete a sensor learn, perform the following procedure:
NOTE:
- This procedure needs to be completed any time a component of the Digital Key system is replaced.
- Connect a scan tool to the vehicle and access SPS.
- Select the SPS application and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K183 UHF Short Range Low Energy Remote Control Access Transceiver.
- Select Setup to initiate the UHF - VKM Sensor Position Learn.
- Follow the on-screen instructions.
- With a scan tool, clear any DTCs.
- If the sensor learn was unsuccessful due to timing out, disconnect and reconnect the battery and attempt the learn procedure again.
NOTE:
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.